Description:
DESCRIPTION
Usage steps:
■ Preparation: isolate and prepare tooth.
■ Cleaning: resin the preparation with water.
■ Drying: gently air dry until there is no visible water. Do not allow enamel or dentin to dry for an excessive period of time.
■ Applying.BOND Self-Etching Light Cure Adhesive(DSA): dispense 1-2 drops of DSA into a mixing well,apply enough DSA to the entire preparation with a little brush until a shiny surface is achieved and then wait for 10 seconds (DSA should not be applied to much).Use a gentle stream of air to evaporate the solvent for 5 seconds(If using a non self-etching adhesive,an etching step should be used according to the manufacturer's instruction)
■ Cure: light cure for 20 seconds at 500±50mW/cm².Keep the distance to exposure surface less than 4 mm.
■ Applying the Nano Flowable Light Cure Composite(FLC): place selected FLC into cavity preparation following by 20 seconds light cure.The depth of cure is about 2.5mm for 20 seconds cure.(In order to reduce shrinkage stress,for a large cavity, an increment filling is recommended.in general,1-2mm increments are placed into cavity preparation from different sides and the restoration is built incrementally.Each increment is light cured for 20 seconds.) For A2 and A3.
■ Finishing: after light cure,adjust restoration.
■ Polishing: use polishing strip or disc to polish the surface.